A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code ] See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
-
End of diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Transmission Control Module (TCM) ( J217). Refer to => [ Transmission Control Module, Replacing ] See: Service and Repair.
Final procedures
1. Check the DTC memory. => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase DTC memory of the Transmission Control Module (TCM) (J217). => [ Diagnostic Mode 04 - Erase DTC Memory ] See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes/Diagnostic
Mode 04 - Erase DTC Memory.
3. Generate readiness code. => [ Readiness Code ] See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors,
Trips, Drive Cycles and Readiness Codes.
End of diagnosis