A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
Clutch Switch: Service and Repair
Clutch Pedal Switch
Clutch Pedal Switch
‹› In order to guarantee sufficiently secure seating, the Clutch Pedal Switch (F36) may only be installed once.
Removing
-
Remove storage compartment on driver side.
-
Disconnect the connector - 1 - on the clutch pedal switch.
‹› Clutch pedal - 3 - is in rest position (not actuated). The Clutch Pedal Switch (F36) plunger - arrow - must touch clutch pedal.
-
Release Clutch Pedal Switch (F36) - 2 - by turning it to the left 45° and pulling it from the guide.
Installing
Install in reverse sequence; note the following points:
-
Now, before installing Clutch Pedal Switch (F36 ), pull plunger - arrow - out completely.
‹› The clutch pedal must remain in rest position (not actuated).
-
Guide the Clutch Pedal Switch (F36) through the installation opening, press it against the clutch pedal and secure it by rotating it 45° to the right.