A4 Quattro Cabriolet V6-3.0L (BGN) (2005)
/Page-1158001.png)
Fluid - A/T: Procedures
ATF Level In Planetary Gearing, Checking and Correcting
ATF Level In Planetary Gearing, Checking and Correcting
Special tools, testers and auxiliary items required
‹› Vehicle Diagnosis, Testing and Information System ( VAS 5051B)
‹› Oil Collecting and Extracting Device (V.A.G 1782 )
‹› ATF Filler Tool (V.A.G 1924)
‹› Protective glasses
Test Conditions
‹› Transmission not in emergency operating mode.
‹› Move the vehicle onto a 4-column lifting platform or over a work pit so it is completely level.
‹› Exhaust hose/-hoses of an exhaust extraction system connected.
‹› Selector lever in "P", let engine run at idle.
‹› Air conditioning and heater switched off.
‹› Vehicle Diagnosis, Testing and Information System ( VAS 5051B) connected, "OBD", Vehicle System " 02 - Transmission Electronics",
"Measured Values, Display Group 4" selected.
‹› ATF temperature must not be higher than 30°C at start of test, allow transmission to cool down if necessary.
Checking ATF temperature
Display on (VAS 5051B):
-
Read off ATF temperature indicated in display field - 1 -.
ATF, Checking Level and Correcting
‹› The ATF level is checked at the ATF inspection plug.
‹› The ATF level is correct if a small amount of fluid drips out of the inspection opening (this is normal as the fluid expands as it heats up) at an ATF
temperature between 35 °C and 45 °C (for hot countries 50 °C).
-
Fill the reservoir of the ATF Filler Tool (V.A.G 1924) with ATF for automatic transmission 01V; ATF specification => [ Capacities ] .
CAUTION!
The ATF filler tool must be clean and the ATF must not be mixed with any other ATF oils!
-
Secure ATF Filler Tool (V.A.G 1924) reservoir as high as possible on vehicle.
