A4 Quattro Cabriolet V6-3.0L (BGN) (2005)
-
Remove heat shield for driveshaft from cover for Torsen differential (arrows).
-
Unbolt driveshaft from transmission and hang or support.
-
Unbolt front heat shield, if installed, from below shift mechanism housing.
-
Remove lower cover from shift mechanism (arrows).
-
Remove boot of selector lever cable from lower shift mechanism cover and slide back.
-
Remove retaining clip -1- for selector lever cable on shift mechanism downward.
-
Pull plastic securing spring -2- slightly to front and push pin -3- up only as far as necessary (arrow).
-
Pull selector lever cable -4- out of shift mechanism at the same time, and do not bend.
Note: Do not bend or kink selector lever cable.
-
Unscrew nuts (arrows).