A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
‹› Make sure that both puller lever arms are parallel to each other when using greatest force.
-
Remove nut - 1 -, remove hex bolt and lift out both control arms - 2 - upward.
The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
-
Swing wheel bearing housing in direction of arrow away to side, when doing this remove drive axle pin from wheel hub.
-
Secure drive axle to body, e.g. with wire.
-
Remove nut from linkage stub of track control arm.
-
Take off wheel bearing housing.
Installing
-
Install wheel bearing housing.
-
Install outer drive axle joint into the hub and tighten with a new hex bolt by hand.
-
Insert control arm and guide link joint pins in wheel bearing housing.
-
Install new self-locking nuts and tighten counterhold joint pins, e.g. with 4 mm hex socket head wrench.
-
Insert both upper control arm joint pins in wheel bearing housing and bend downward as much as possible using Pliers (T40067 ).