A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Set aside Engine Control Module (ECM) with cables connected.
-
Unclip Transmission Control Module (TCM) retaining bracket.
-
Set aside Transmission Control Module (TCM) with cables still connected.
-
If present, cut through cable ties.
-
Disconnect connectors at rear of connector rail.
-
Unscrew wire connection - 2 -.
-
Remove bolts - 1 - and - 3 -.
-
Unclip the corresponding connector base.
‹› Check the exact assignment for connection point E-Box plenum chamber in the current wiring diagram.
‹›
Installing
Installation is reverse of removal, paying attention to the following:
‹› All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
Tightening Specifications