A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Check the wiring connection for an open circuit or a short circuit Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to Fuel Injection and Ignition Repair Information.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623 ). Refer to => [ ECM, Removing and Installing ] See: Engine Control Module/Service and
Repair/ECM, Removing and Installing.
-
Using a Multimeter, Check the Camshaft Adjustment Valve electrical harness connector terminal 2 to the Engine Control Module (ECM) (J623)
electrical harness connector T60 terminal for an open circuit.
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).