A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Loosen lower nuts - 1 - at left and right engine mounts a few turns.
-
Push transmission to left.
-
Remove front exhaust pipe with catalytic converter.
Installing
Installation is in reverse order of removal, noting the following:
‹› Replace gaskets and self-locking nuts.
‹› During installation, all cable ties must be re-installed at the same location.
‹› Oxygen sensor wires must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.
-
Fasten ATF lines.
-
Install subframe.
-
Install drive axle.
-
Align engine free of tension.
-
Align exhaust system free of tension => [ Exhaust System, Installing ] See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Removal and Replacement/Exhaust System, Installing.
‹› Individual exhaust system mounting parts on transmission for vehicles with multitronic transmission 01J => [ Individual right mounting
components for vehicles
with multitronic transmission 01J ] See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair/Removal and Replacement/Exhaust System
Component Overview
-
Check ATF level.
Tightening Specifications