A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Unclip suction jet pump from locking flange with Fuel Level Sensor 2 (G169).
-
Remove locking flange with Fuel Level Sensor 2 ( G169).
Installing
Installation is in reverse order of removal, note the following:
‹› Replace seal.
‹› When inserting, be sure not to bend floater arm of Fuel Level Sensor 2 (G169).
-
Clip the suction jet pump to the locking flange so that it is audibly engaged.
-
Carefully insert Fuel Level Sensor 2 (G169) in fuel tank opening.
-
Install the new locking flange seal dry.
-
Press locking flange down against spring pressure and bring it into installation position.
‹› The tab - 2 - on locking flange must lie between tabs - 1 - and - 3 - on fuel tank.
‹› - Arrow - points in direction of travel.
-
Tighten locking ring.
-
Connect battery. Observe safety precautions after connecting battery.