A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Using a multimeter, check the Intake Manifold Runner Position Sensor 2 (G512) electrical harness connector terminals to the Engine Control
Module (ECM) ( J623) electrical harness connector T60 terminals for an open circuit.
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring:
-
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ ECM, Removing and Installing ] See: Computers and Control Systems/Engine
Control Module/Service and Repair/ECM, Removing and Installing.
-
Install the rear engine cover - arrows -.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and Inspection/Scan Tool
Testing and Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. => [ Readiness Code ] See: Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
-
End of diagnosis.