A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Control Module: Testing and Inspection
Transmission Control Module (TCM) J217 Voltage Supply, Checking
Transmission Control Module (TCM) J217, Voltage Supply, Checking
NOTE: The Transmission Control Module (TCM) J217 is a component of the mechatronic unit in the transmission and cannot be replaced separately.
Special tools, testers and auxiliary items required
-
Multimeter.
-
Wiring diagram.
Requirements
-
The Transmission Control Module (TCM) J217 fuses OK.
-
The battery voltage must be at least 12.5 volts.
-
The Ground (GND) connections at the transmission OK.
-
The parking brake engaged.
-
The selector lever of automatic transmission in position "P".
-
All electrical consumers switched off.
-
The ignition switched off.
Test sequence
-
Disconnect the Transmission Control Module (TCM) J217 electrical harness connector - direction of the arrow -.
-
Check the electrical harness connector for damage, contact corrosion, or ingress of water.
If the electrical harness connector is not OK:
-
Repair the malfunction.
If the electrical harness connector is OK:
Checking voltage
-
Switch the ignition on.
-
Using a Multimeter, check the Power Supply Relay (terminal 15) J329 socket 2/87 to Ground (GND).
Specified value: battery voltage.
-
Switch the ignition off.
If the specified value was not obtained:
-
Check the wiring from the Power Supply Relay (terminal 15) J329 socket 2/87 to the Transmission Control Module (TCM) J217 electrical harness
connector terminal 9 for an open circuit or a short circuit.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
-
Using a Multimeter, check the Transmission Control Module (TCM) J217 electrical harness connector terminal 14 to Ground (GND).
Specified value: battery voltage.
If the specified value was obtained:
-
Check the wiring from the Battery to the Transmission Control Module (TCM) J217 electrical harness connector terminal 14 for an open circuit or
a short circuit.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained: