A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Loosen two bolts - 6 -.
-
Remove head-level airbag - 1 - from vehicle.
‹› Installing:
CAUTION!
Note safety precautions for working on airbags. Refer to => [ Airbag System Safety Precautions ] See: Service Precautions and side
curtain airbags => [ Side Curtain Airbag Safety Precautions ] See: Service Precautions/Side Curtain Airbag Safety Precautions.
CAUTION!
Always follow side curtain airbag installation procedure.
-
Insert center bracket - 2 -.
-
Insert remaining brackets - 2 -.
-
Install two bolts - 6 -.
-
Tighten bolt - 7 -.
-
Secure airbag module to B-pillar with two bolts - 5 -. Refer to => [ Side Curtain Airbag Fastener to B-Pillar ].
-
Secure three brackets - 2 - using three bolts - 5 -.
-
Install last bolt - 5 -.
-
Install outer bolts - 4 -.
-
Install center bolt - 4 -.
Further installation is performed in the reverse order of removal. Observe the following when doing so:
-
Switch on ignition.
CAUTION!
No one should be in vehicle when connecting battery.
-
Connect the battery ground (GND) strap.
‹› Follow safety measures after connecting battery.
‹› If the Airbag Malfunction Indicator Lamp (MIL) ( K75) shows a malfunction after assembly, DTC memory must be checked with Vehicle
Diagnostic, Testing and Information System ( VAS 5051 A), cleared and then rechecked.
2
Bracket (Qty. 5)
3
Tab
4
Bolts (Qty. 3)
‹› Tightening specification 4 Nm
‹› Self-locking
‹› Replace after each disassembly
‹› Threaded holes for screws must always be cleaned (for example, with thread cutter)
5
Screws (Qty. 6)
‹› Tightening specification 4 Nm
‹› Self-locking