A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Release cable retainer - 2 - in direction of arrow by prying out at cut-out - 3 -.
The illustration shows the released cable retainer - 2 -.
-
Remove cable - 4 - for belt fasten sensor from sockets 5 and 6 and on the driver's side (in certain countries), the cable - 4 - for the switch in safety
belt latch socket 1 and 2 as well.
-
Open cable ties.
Installing
CAUTION!
Observe:
‹› Airbag safety precautions.
‹› Safety precautions for working with pyrotechnic belt tensioners, refer to => [ Pyrotechnic Belt Tensioners Safety Precautions ] See:
Seat Belt Tensioner/Service Precautions
‹› Seat belt inspection, refer to => [ Seat Belts, Inspecting ] See: Repairs and Inspections Required After a Collision/Service and
Repair/Seat Belts, Inspecting.
To install, perform the steps used in removal in reverse order.
-
Replace the bolt on the safety belt latch.
Tightening Specifications
Version 2
CAUTION!
Observe:
‹› Airbag safety precautions.
‹› Safety precautions for working with pyrotechnic belt tensioners, refer to => [ Pyrotechnic Belt Tensioners Safety Precautions ] See:
Seat Belt Tensioner/Service Precautions
‹› Seat belt inspection, refer to => [ Seat Belts, Inspecting ] See: Repairs and Inspections Required After a Collision/Service and
Repair/Seat Belts, Inspecting.
Removing
-
If present, disconnect connector - 1 - under seat equipment versions.