A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
CAUTION!
Follow instructions for disconnecting the battery.
-
Disconnect battery.
-
Remove the rear bench seat. Refer to => [ Rear Bench Seat ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear
Seats.
-
Remove rear seat backrest. Refer to => [ Rear Seat Backrest ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear
Seats.
-
Open the convertible top compartment
-
Remove screw - 8 -.
-
Disconnect the safety belt tensioner connector. Refer to => [ Disconnecting the Rear Safety Belt Tensioner
Connector ].
-
Remove belt roller - 9 -.
-
Remove screw - 7 -.
-
Unclip the front belt webbing guide - 2 - and remove it - 2 -.
-
Open the connecting bar - 3 - on the belt webbing guide - 2 -.
-
Remove the belt webbing - 1 - from the belt webbing guide - 2 - and the relay bracket - 4 -.
‹› Installing
-
Install the connector on the belt tensioner.
-
Connect the safety belt roller - 9 - with the bolt - 8 -.
-
Guide the belt webbing - 1 - into the relay bracket - 4 -.
-
Guide the belt webbing - 1 - into the belt webbing guide - 2 - with the connecting bar open - 3 -.
-
Close the connecting bar - 3 -.
-
Install the rear belt webbing guide - 2 - and then push on it - 2 -.
-
Make sure the front belt webbing guide - 2 - is secure in the side trim.
-
Make sure the outer floor assembly anchorage point - 6 - locks into the securing nub - 5 -.
-
Secure the outer floor assembly anchorage point - 6 - with the bolt - 7 -.
-
Install the rear safety belt in reverse order to removing.
10 - Belt Latch Tongue
Disconnecting the Rear Safety Belt Tensioner Connector