A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Press red connector housing - 1 - back.
-
Cable pin - 6 - (Qty. 2) for belt fasten sensor.
-
Red connector housing - 1 - for belt fasten sensor and main voltage supply.
-
Release cable retainer - 2 - in direction of - arrow - by prying out at cut-out - 3 -.
The illustration shows the released cable retainer - 2 -.
-
Remove cable - 4 - for belt fasten sensor from sockets 5 and 6 and on the driver's side (in certain countries), the cable - 4 - for the switch in safety
belt latch socket 1 and 2 as well.
-
Open cable ties.
Installing
CAUTION!
Observe safety precautions. Refer to => [ Pyrotechnic Belt Tensioners Safety Precautions ] See: Seat Belt Tensioner/Service Precautions
Installation is performed in reverse order of removal, noting the following.
-
Replace the bolt on the safety belt latch.
Tightening Specifications