audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Seat Belt|Service and Repair > < Seat Belt|Service Precautions|Page 10491
Page 3
background image

Child-seat Restraint Function For Additional Child Seats (not For Drivers Seat Belt), Checking

-

The complete belt assembly (including side panel trim) must be installed when checking this function.

-

Activation of restraint function:

-

Pull out webbing as far as possible.

-

Correct function:

-

The belt should retract with an audible noise.

-

If the belt retraction is stopped, it should not be possible to pull the belt out again until the function is deactivated.

-

Deactivation:

-

Allow the belt to retract as far as the last 100 mm (approx.).

-

Restraint function must be deactivated at the latest when the last 100 mm are reached. The belt then re-assumes its normal function.

Belt-fastened Sensor For Rear 3-Point Belts With Belt Tensioner, Checking

-

Switch ignition on.

-

Connect vehicle diagnostic, testing and information system VAS 5051 A or vehicle diagnostic and service information system VAS 5052 and
select vehicle system "15 - Airbag" on.

-

Read measured value block, display group 004.

Belt fully retracted, display on vehicle diagnostic, testing and information system VAS 5051 A or vehicle diagnostic and service information system
VAS 5052: - no -

Latch plate engaged in belt buckle and belt pulled out by dimension - L -, display on vehicle diagnostic, testing and information system VAS 5051 A or
vehicle diagnostic and service information system VAS 5052: - yes -

-

Pull out belt as far as possible. For this purpose, display on vehicle diagnostic, testing and information system VAS 5051 A or vehicle diagnostic
and service information system VAS 5052 must remain - yes -.

-

Retract belt as far as dimension - L - without releasing latch plate, display on vehicle diagnostic, testing and information system VAS 5051 A or
vehicle diagnostic and service information system VAS 5052 must remain - yes -.

-

Release latch plate and slowly retract belt; at the latest when the belt has retracted as far as the last 100 mm, display must switch from - yes - to -
no -.

Belt fully retracted, display on vehicle diagnostic, testing and information system VAS 5051 A or vehicle diagnostic and service information system
VAS 5052: - no -

-

Dimension - L - is 300 mm for left and right belt.

Seat Belt|Service and Repair > < Seat Belt|Service Precautions|Page 10491