A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Clutch Switch: Service and Repair
Clutch Pedal Starter Interlock Switch F194, Removing and Installing
Clutch Pedal Starter Interlock Switch F194, removing and installing, 02X, 6-Speed Four-Wheel Drive M/T
Note:
^
To ensure a secure fit, the clutch pedal starter interlock switch F194 must not be installed more than once.
Removing
-
Remove storage compartment on drivers side.
-
Disconnect electrical connector - 3 - on clutch pedal switch.
-
Press clutch pedal - 1 - all the way down and hold it in this position.
-
At the same time, release clutch pedal starter interlock switch F194 - 2 - by turning it 45° in the direction indicated - arrow - and pull it out of the
guide.
Installing
-
Pull out operating rod - arrow - all the way before installing clutch pedal switch.