A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Steering Column Control Module: Service and Repair
Steering Column Electronics Systems Control Module
Steering Column Switch Module
General Information
The steering column switches, spiral spring and Steering Angle Sensor (G85) are integrated into a single assembly (module) along with the Steering
Column Electronic Systems Control Module (J527).
Before troubleshooting or servicing, technicians must be familiar with the functions and operation specifics of the steering column electronics. Always
read the owner's manual and review applicable system functions.
‹› Additional information:
=> Owner's Manual
=> Self Study Program - Course Number 991103 " 2002 Audi A4 Technical Features"
=> Self Study Program - Course Number 991503 " The 2005 Audi A4"
=> Wiring Diagrams & Component Locations
Steering Column Electronics Systems Control Module
Removing
‹› Should the Steering Column Electronic Systems Control Module (J527) require replacement, follow applicable component " Replacement"
procedure using VAS 5051/5051 in operating mode " Guided Fault Finding".
-
Remove steering column switch module => [ Steering Column Switch Module ].
CAUTION!
‹› Ensure steering is in straight ahead and centered prior to removing spiral spring.
‹› Position of spiral spring must not be changed once removed.
-
Carefully release clip fasteners - arrows - and remove spiral spring - 1 - from steering column switch module.
-
Remove Steering Angle Sensor (G85) - 1 - from Steering Column Electronic Systems Control Module (J527)in direction of - arrow -.