A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Note:
^
When pulling in the hydro-bushing using wheel bearing tool V.A.G. 1459 B, the tool must be repositioned during installation.
^
Make sure that the hydro-bushing remains straight during the first stage of installation, otherwise the outer ring may be damaged.
-
Lift subframe using engine/transmission jack V.A.G 1383 A.
-
Install and tighten new subframe bolts with new washers and (front wheel drive), or and (all wheel drive).
Rear hydro-bushings only
-
Install stabilizer bar.
Front and rear hydro-bushings continued
-
If installed, install diagonal braces - 1 - and - 2 -.
-
Install left and right floor pan panels
-
Install left and right coil springs.
-
Install wheel and fasten.
-
Perform wheel alignment if more than 2 hydro-bushings bolts have been loosened.
Wheel alignment must be performed on wheel alignment equipment recommended by Audi.