A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
3
Hydraulic support
4
Press Piece (T40033/5)
5
Hollow Piston Cylinder ( HKZ-15)
6
Press Piece (E-5)
7
Special Nut (E-8-214)
8
Spindle (T40034)
9 - Subframe
-
Pre-tension special tool with hydraulic mounting.
-
Completely coat hydraulic mounting with installation lubricant G 294 421 A1 thin with water at a ratio of 1:100.
-
Make sure that ends of rubber beads on hydraulic mounting - 1 - align with markings - arrows B and C - on subframe - 2 -.
- Arrow A - is in direction of travel
-
Pull in hydraulic pump to stop by operating pump.
‹› When pulling in hydraulic mounting with Wheel Bearing Tool (V.A.G 1459 B) you must cut back.
‹› Make sure that hydraulic mounting does not tilt while it is being pulled in, otherwise outer ring could be damaged!
-
Raise subframe using Engine/Transmission Jack ( V.A.G 1383 A).
-
Install new subframe bolts and washers and tighten
Only rear hydraulic mounting
-
Install stabilizer bar. Refer to => [ Stabilizer Bar ] See: Stabilizer Bar/Service and Repair/Rear Suspension/Stabilizer Bar.
Procedure for front and rear hydraulic mountings
-
If present, install diagonal braces - 1 - and - 2 -. Refer to => [ Front or Rear Diagonal Braces ] See: Body and Frame/Frame/Structural
Brace/Service and Repair/Rear Suspension.