A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Operation/Rear Suspension/AWD.
-
Tighten bolts - 2.
Pay attention to the location of the lower mounting => [ Shock absorber location ] See: Description and Operation/Rear Suspension/FWD.
-
Bonded rubber bushings have a limited torsional range. Only tighten threaded connections at control arms if vehicle is in curb weight position.
Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures/Rear Suspension.
-
Tighten connection - 1 .
-
Install coil spring. Refer to => [ Coil Spring ] See: Suspension Spring ( Coil / Leaf )/Service and Repair.
On vehicles with Dynamic Ride Control (DRC II), fill the system. Refer to => [ Dynamic Ride Control, Emptying and Filling ] See: Suspension
Control ( Automatic - Electronic )/Service and Repair.
-
Mount wheel and tighten.