A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Draining ATF
-
Place drip tray V.A.G 1306 under transmission.
CAUTION! Wear safety goggles.
-
Remove ATF drain plug - arrow A -.
-
Drain ATF.
Note:
^
Observe relevant disposal regulations.
^
The engine must not be started and vehicle must not be towed without ATF in transmission.
^
The drain plug with seal must be replaced.
-
Tighten new drain plug - arrow A - to 12 Nm.
Filling with ATF
-
Remove ATF inspection plug - arrow B -.
-
Guide filler nozzle of ATF charging device V.A.G 1924 in from below through an opening in deflector cap - arrow -, taking care not to push
deflector cap upward out of position.
-
Fill with ATF using ATF charging device V.A.G 1924 until ATF comes out of inspection hole.
-
Shift selector lever to position "P".
-
Start engine and let it idle.
-
Continue filling with ATF using ATF charging device V.A.G 1924 until ATF comes out of inspection hole again.
-
Tighten ATF inspection plug.
-
With engine idling, press brake pedal and shift selector lever through all selector lever positions leaving selector lever at least 10 seconds in each
position.
-
Shift selector lever to position "N".
-
Increase engine speed to 2000 rpm and maintain for at least 60 seconds.
-
Shift selector lever to position "P".
-
Check ATF level.
Note: Observe all notes and test requirements for "Checking and correcting ATF level".