A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Drive out roll pin - 1 - at selector shaft lever - 2 - - arrow - until it is possible to detach selector shaft lever from selector shaft.
-
Push a small screwdriver through seal and pull it out.
-
Lubricate outer circumference and the space between sealing lips of seal with ATF.
-
Install new seal onto selector shaft.
^
Installation position: open side of seal faces transmission.
-
Press on new oil seal using thrust piece T10135 and assembly lever - A - as far as stop; make sure that oil seal remains straight.
Note: To prevent slippage when pressing in oil seal, place something as a base (e.g. piece of rubber) between assembly lever and subframe - arrow - .
-
Before installing, drive roll pin in selector shaft lever back through lever in opposite direction.
-
Push selector shaft lever onto selector shaft and drive in roll pin.