A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Shifter A/T: Removal and Replacement
Selector Lever Handle, Removing and Installing
Selector lever handle, removing and installing - 09L, 6 Speed AWD A/T
Removing
-
Shift selector lever to position "D".
-
Turn sleeve - 1 - counter-clockwise and push down onto stop.
-
Pull button - 2 - out of selector lever handle - 3 - carefully, just far enough to be able to insert a cable tie between button and selector lever.
Note: Under no circumstances pull button out further, as selector lever handle would then become damaged.
-
Use cable tie to secure the button in its pulled position - arrow -, as shown in illustration.
-
Remove selector lever handle by pulling it off.
Installing
Installation is performed in reverse sequence. Note the following:
-
Shift selector lever to position "D".
Note:
^
To install the selector lever handle - 3 - the button - 2 - has to be pulled out to the stop and must be secured with either a cable tie - arrow - or with
the assembly aid supplied together with the new handle.
^
If, by mistake, the button has not been secured, it must not be pulled out of the selector lever handle using mechanical tools. Position a compressed
air gun at the bottom of the handle and carefully press the button out with compressed air.
-
Install selector lever handle - 3 - fully onto selector lever; button - 2 - points toward the driver. The handle must engage in annular groove of
selector lever.
-
Remove cable tie - arrow - or assembly aid; the button mechanism will then engage in the vertical groove on the selector lever. If necessary, press
button into selector lever handle.
-
Pull sleeve - 1 - upward and engage by turning in clockwise direction.