A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
1 - Release bearing
^
Do not wash out; wipe clean only
^
Replace bearings if noisy
^
Servicing release bearing with glued plastic ring
^
Checking release bearing with mechanically attached plastic ring
^
Replace if running mark (groove) is too deep
^
Retainer tabs on release bearing must engage in release lever
2 - TORX bolt, 35 Nm
^
3x
^
Apply locking fluid AMV 185 101 A1 when installing
3 - Clutch release lever
^
Before installing, lubricate area which makes contact with operating rod of slave cylinder with copper grease Z381351TE.
4 - Retaining spring
^
Secure to clutch release lever
5 - Guide sleeve
^
Installation position: Oil drain hole points downward.
^
Before removing and installing, cover input shaft splines with a shrink-fit hose to protect oil seal.
6 - Seal
^
For input shaft
^
Pack space between sealing lip and dust lip half full with sealing grease G052128 A1.
7 - O-ring
^
Always replace
8 - Convex washer
9 - Intermediate piece
^
Installation position: insert locating element between ribs of housing