A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-1985002.png)
-
Remove rear part of exhaust system from clamping sleeves - arrows -.
-
Pry off mountings - A - for heat shield above intermediate bearing.
-
Remove mounting bolts for intermediate bearing - B -. When doing this, support driveshaft by hand.
-
Remove heat shield while supporting driveshaft.
-
Install mounting bolts for intermediate bearing by hand.
Audi A6:
-
If present, remove rear transverse beam - 1 -.
-
Remove heat shield - 3 - from vehicle floor - arrows -.
Continuation for all vehicles: