A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
4 - CV joint boot with cap
^
Check inner constant velocity joint if boot is damaged.
^
Check for splits and chafing
^
Replace only as a complete assembly
^
Sealing surfaces (boot/drive shaft and boot/cap) must be free from grease when assembling
5 - Lock plate
6 - Multi-point socket-head bolt
7 - Drive shaft
8 - Hose clip
^
Always replace
9 - Boot for outer constant velocity joint
^
Without vent hole
^
Check for splits and chafing, replace if necessary
^
If damaged, check outer constant velocity joint
^
Sealing surfaces must be free of grease when assembling.
10 - Hose clip
^
Always replace
11 - Circlip
^
replace
^
Installation position
12 - Dished washer
^
Installation position
13 - Spacer ring (plastic)
^
Installation position
14 - Circlip
^
Always replace
^
Insert in groove on shaft
15 - Outer constant velocity joint
^
Replace only as a complete assembly
^
Installing: drive onto shaft with plastic hammer until compressed circlip seats
^
Circlip must fit in chamfer on joint when installing; guide with pliers if necessary.
^
Greasing
16 - Bolt
^
Always replace if removed
^
Loosening
^
Tightening
^
Tightening torque