A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Constant Velocity Joint: Overhaul
Triple Roller Joint AAR 2600 i or 3300 i, Assembling
Triple Roller Joint AAR 2600 i or 3300 i, Assembling
Assembly
-
Slide new protective boot onto drive axle.
-
Press on circlip - 1 - to center of splines
-
Use special tool shown in illustration.
Depending on driveshaft version, (T10065/3) must be used instead of Assembly Device (T10065/2).
Tripod roller star, pressing onto drive axle
The chamfer on star faces toward drive axle, this is used as an assembly aid.
-
Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.
-
Place triple roller star on shaft according to marking and drive on until impact.
This illustration only applies to conical drive axles - arrow -!