A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Install triple roller star onto shaft according to markings and drive onto stop.
A second mechanic is required to push boot back.
Use tube trans drive shaft VW426 shown in illustration.
Install circlip (ensure proper seating).
-
Press 80 grams of drive axle grease from repair kit into triple roller joint.
-
Slide joint body over rollers and hold in position.
-
Press 30 grams of drive axle grease from repair kit into rear of triple roller joint.
-
Install joint boot. The bead on the CV joint boot must engage in the joint body groove.
-
Remove drive axle from vise and clamp joint body in position in vise.
-
Insert new seal - arrow - from repair kit into groove.
-
Install new cover on joint body. Holes in cover and joint must align.
-
Install clamp
Observe note.