A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
‹› Tightening specification => [ Install drive axle ] See: Service and Repair/Removal and Replacement/Front Suspension.
2 - Clamp
‹› Replace
3 - CV boot
‹› Check for tears and scuffing
‹› Before clamping hose clamp, raise protective joint boot briefly to balance pressure.
4 - Clamp
‹› Replace
5 - Socket head bolt
6 - Joint piece
7 - Triple rotor star with rollers
‹› Chamfer - arrow - faces splines drive axle splines
‹› When installing triple roller star on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
8 - Securing ring
‹› Replace
9 - Sealing ring
‹› Replace
10 - Cover
‹› Replace
11 - Clamp
‹› For triple roller joint
‹› Replace
12 - CV boot for triple roller joint
‹› Check for tears and scuffing
‹› Before clamping hose clamp, raise protective joint boot briefly to balance pressure. Joint must be in center position for this.
13 - Drive axle
14 - Securing ring
‹› Replace
‹› Insert in shaft groove
15 - Outer constant velocity joint
‹› Replace only as complete unit
‹› Installing: Drive onto shaft using plastic hammer until compressed circlip seats.
‹› Greasing