A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
‹› If it does not move freely, e.g. due to dirt in thread, the required clamp tension will not be achieved at the specified torque.
Pressing off outer CV joint
-
Secure drive axle with protective covers in vise clamp.
-
Remove big hose clamp and pull back CV boot.
-
Screw Pressure Spindle (3207) into joint bolt until CV joint can be removed.
Venting CV boot
Applies to rubber CV boots only:
A vacuum can form in the joint when installing the protective joint boot.
This vacuum pulls a fold inward when the car is driven - arrow -.
Therefore, note the following:
-
Before tightening the hose clamps, balance the pressure by raising the protective joint boot.