A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Avoid damaging oil seal - C - by only installing oil seal and selector shaft using assembly sleeve assembly sleeve 01E311120 - A -.
-
Pack space between sealing lip and dust lip half full with sealing grease G052128A1.
-
Lightly oil outer circumference of seal.
-
Drive oil seal - arrow - into housing as far as it will go.
The remaining installation steps are in reverse order of removal. Note the following:
Vehicles with 6-cylinder engine:
-
Install exhaust system and perform stress-free alignment.
-
Install heat shield for drive shaft (left-side).
Continued for all vehicles:
-
Check gear oil level in transmission.
Tightening torques