audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Auxiliary Cabin Heater|Description and Operation|Page 9087 > < Outside Air Temperature Sensor|Page 9083
Page 1
background image

Auxiliary Cabin Heater: Description and Operation

Auxiliary Air Heater Heating Element

‹› On vehicles with a diesel engine, an electrical auxiliary heater is currently installed. Refer to Audi Sales Program. The air is supplied with heat

energy after leaving the heater core if there is a request from the Climatronic Control Module (J255) A/C control head. 

‹› The electrical auxiliary heater (the Auxiliary Air Heater Heating Element (Z35)) is activated via the respective engine control module (the control

modules exchange information about this via the databus system). Refer to Vehicle Diagnosis, Testing and Information System VAS 5051 in
"Guided Fault Finding" function. 

‹› No auxiliary heater is currently installed on vehicles with gasoline engine. 

‹› On gasoline engine vehicles and diesel engine vehicles without an Auxiliary Air Heater Heating Element (Z35) installed, there is a place holder in

the honeycomb in the A/C. Refer to=> [ Air Routing in Air Intake Housing and A/C Unit ] See: Housing Assembly HVAC/Service and
Repair/Overhaul/Air Routing in Air Intake Housing and A/C Unit

‹› In MY 2009, as a running change, a new version of the Auxiliary Air Heater Heating Element (Z35) is being installed the heating element is

slightly narrower be sure to use the correct version and note the allocation.

Removing

-

Switch on the ignition.

-

Set the air flow direction to "DEF" on the Climatronic Control Module (J255).

-

Move the passenger seats as far back as possible.

-

Switch off ignition.

-

Air Intake Housing, removing. Refer to=> [ A/C Unit Air Intake Housing ] See: Air Register/Service and Repair/Instrument Panel Vents and Air
Ducts 

-

Disconnect the connector from the Evaporator Vent Temperature Sensor (G263). Refer to=> [ Evaporator Vent Temperature Sensor ] See:
Evaporator Temperature Sensor / Switch/Service and Repair. 

-

Carefully fold back the carpet around the center console and loosen the ground connection to the Auxiliary Air Heater Heating Element (Z35) - A
- from the ground point on the right side of the center tunnel. 

CAUTION!
When folding back the carpet, be careful not to damage the center console.

-

Disconnect the connector - B - and loosen the connector -  C - from the right radiator housing.

-

 Loosen the Auxiliary Air Heater Heating Element (Z35)- D - wiring from the brackets on the right radiator housing.

Auxiliary Cabin Heater|Description and Operation|Page 9087 > < Outside Air Temperature Sensor|Page 9083