A4 Quattro Sedan V6-2.8L (ACK) (1997)
-
Bumper -4- height is adjusted by shifting threaded sleeve -3- in impact absorber -2-.
-
Tighten combination bolt -1- to 23 Nm (17 ft lb).
Fig. 2 Bumper Bracket
-
To remove, remove bolts -3- and take off bracket -2-.
-
To assemble, press in clip -1-.
Fig. 3 Installing License Plate Holder
NOTE: Use license plate holder as a drill hole template
-
Open hood
-
Cover area in center of bumper and license plate holder with adhesive tape -4- as shown.
-
Mark middle of bumper -3- and license plate holder -2- (arrows) on adhesive tape using fine felt tip pen.
-
Slide license plate holder in one continuous motion from bottom to top of bumper in centered position.
-
Mark holes on bumper.
-
Using drill (8 mm - 10 mm), drill holes centered around marks through bumper cover.
-
Secure licence plate holder -2- on bumper -3- using bolts -1-.