A4 Quattro Sedan V6-2.8L (ACK) (1997)
Trunk / Liftgate Weatherstrip: Service and Repair
The butt joint -A- of the rear lid seal must be aligned with the ball socket of left hinge.
Removing and installing handle mechanism for rear lid
-
Remove bolts -1- (2x).
-
Tightening torque: 2.5 Nm (22 in. lb)
-
Attachment point -A-; remove nuts (2x) for lock cylinder on inside of lid.
-
Tightening torque: 6 Nm (53 in. lb)
-
Pull handle mechanism -3- out enough that harness connectors for both license plate lights can be disconnected.
-
Remove handle mechanism.
-
Install nuts -2- (2x) using special tool VAG1618A.
Panel gap dimensions
-
a
-
3.0 mm
Removing and installing holder for warning triangle