A4 Quattro Sedan V6-2.8L (ACK) (1997)
If resistance is NOT OK:
-
Disconnect 8-pin harness connector for throttle valve control module -J338-.
-
Check wiring for open circuit between ECM/test box and 8-pin harness connector.
-
Connector terminal 3 to ECM/test box socket 69
-
Connector terminal 7 to ECM/test box socket 67
-
Specified value: max. 1.5 ohms
-
Check wiring for short circuit between ECM/test box and 8-pin harness connector.
-
Connector terminal 7 to ECM/test box socket 69
-
Specified value: Infinity ohms
-
Reconnect throttle valve control module harness connector.
If wiring is OK:
-
Replace throttle valve control module -J338-.
-
Carry out adaptation of throttle valve control module to ECM.
-
Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.