A4 Quattro Sedan V6-2.8L (ACK) (1997)
-
Switch multimeter to 20 VDC measuring range.
-
Check wiring at 3-pin connector for short circuit to B+ (battery positive voltage), according to applicable wiring diagram.
-
Connector terminal 1 to vehicle Ground
-
Connector terminal 2 to vehicle Ground
-
Specified value: 0 volts
If wiring is OK:
-
Replace Mass Air Flow sensor (MAF) -G70-.
-
Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.