A4 Quattro Sedan V6-2.8L (ACK) (1997)
-
Remove bolt -1- mounting suspension strut to lower track control link.
-
Remove suspension strut downward.
Notes:
-
When removing the suspension strut, make sure that the CV joint boot is not damaged.
Installing
-
Install suspension strut.
-
Hole in spring plate (arrow) faces toward middle of vehicle.
CAUTION: The bonded rubber bushings can only be turned to a limited extent. The bolted connections between the suspension strut and the
lower track control links should therefore only be tightened when the vehicle is standing on the ground.
-
Bolt suspension strut to track control link and tighten new nut -1-.
Tightening torque: 90 Nm (66 ft. lbs.)