A4 Quattro Sedan V6-2.8L (ACK) (1997)
Shift Interlock Solenoid: Service and Repair
Tiptronic Selector Mechanism
Removing and installing shift lock solenoid
Removing
-
Remove shift mechanism.
-
Remove stop buffer from cable lever.
-
Move selector lever into Tiptronic gate, then remove frame.
-
Move selector lever to "2" position.
-
Lift lever for lock cable, detach from mounting, and remove from mounting bracket.
-
Press out pin for locking pawl using drift.
-
Lift out shift lock solenoid together with locking pawl.
Installing
-
Move selector lever to "2" position.
-
Insert shift lock solenoid in mounting bracket from above together with locking pawl.
-
Carefully drive in pin for locking pawl.
-
Use screwdriver to make sure locking pawl is properly engaged with selector lever in "P" and "N" positions.
-
Place locking lever in mounting bracket and make sure it engages properly at both mountings.
-
Check operation of locking lever.
With the selector lever in position "P", the locking lever should engage the detent and make it impossible to change gear.
-
Place frame on mounting bracket (ribbed side upward) and insert stop buffer in cable lever.
-
Install shift mechanism.