A4 Quattro Sedan V6-3.0L (AVK) (2002)
Front Bumper Cover / Fascia: Service and Repair
Centering Holes For Side Impact Moldings
Centering Holes For Side Impact Moldings
Up to Vehicle Identification Number (VIN) 400 000
1
-
Front bumper
-
Position hole to vehicle outside - arrow B - according to marking on bumper.
NOTE: If there is no marking in this position, the long hole (as depicted in illustration) must be manufactured at upper/outer edge,
according to the lines on bumper.
-
Position hole to vehicle center - arrow A - according to marking on bumper.
Positioning centering holes
-
Position of long holes is indicated by markings on bumper.
-
Long hole must be aligned to dimensions - a - = Dia 8.5 mm and b = 15.5 mm as shown
-
If there is no marking in this area, the long hole must be aligned according to the indicated lines on bumper as shown, with upper edge to
horizontal line and with outer edge to vertical line.