A4 Quattro Sedan V6-3.2L (BKH) (2005)
/Page-2832004.png)
-
Remove selector lever cable sleeve from selector mechanism cover (bottom) and slide back.
-
Remove cover on underside of selector mechanism - arrows -.
-
Remove retaining clip - 1 - for selector lever cable by pulling it off downward at selector mechanism.
-
Pull plastic securing spring - 2 - slightly forward and press pin - 3 - upward, but only as far as is necessary - arrow
Note:
^
Make sure that pin is not pressed out completely.
-
Pull selector lever cable - 4 - out of selector mechanism.
Note:
^
Do not bend or kink the selector lever cable.
Installing
Installation is performed in reverse sequence. Note the following:
-
Install new retaining clip - 1 - for selector lever cable on selector mechanism.
^
Installation position: The angled end of retaining clip faces to the inside of selector mechanism.
-
Insert end of selector lever cable - 4 - in joint on selector lever.
-
Push pin - 3 - down - arrow -.
-
Check that plastic securing spring - 2 - has locked the pin.
