A4 Quattro Wagon L4-1.8L Turbo (AEB) (1999)
-
Drive in right-hand drive flange seal 5.5 mm (0.216 inch) below outer transmission housing surface using VW195 arbor, without canting.
Note: If reinstalling an old drive flange, the new seal must be pressed in about 6.5 mm (0.256 inch), so that the new seal does not sit on the
running surface of the old seal.
-
Drive in left drive flange seal 5.5 mm (0.216 inch) below outer transmission housing surface using VW195, without canting.
Note: If reinstalling an old drive flange, the new seal must be pressed in about 6.5 mm (0.256 inch), so that the new seal does not sit on the
running surface of the old seal.
-
Install drive flange using VW295 needle bearing drift.
-
Bolt drive axle on drive flange.
-
Install drive axle heat shield.
-
Check transmission oil level.
Tightening torques
Component ........................................................................................................................................................................................ Tightening Torque
Drive Axle to Drive Flange
-
M8 ................................................................................................................................................................................................... 40 Nm (30 ft. lb.)
-
M10 ................................................................................................................................................................................................. 80 Nm (59 ft. lb.)
Heat Shields to Drive Axles .................................................................................................................................................................. 23 Nm (17 ft. lb.)