A4 Quattro Wagon L4-1.8L Turbo (ATW) (2000)
Piston: Service and Repair
Pistons and connecting rods, disassembling and assembling
1 - Nut for connecting rod bolt
^
30 Nm (22 ft. lbs.) + additional 1/4 turn (90°)
^
Always replace connecting rod bolt -13-
^
Grease thread and contact surface
^
To measure radial play, tighten to 30 Nm (22 ft. lbs.) but not any further
2 - Pressure relief valve
^
Tightening torque: 27 Nm (20 ft. lbs.)
^
Opening pressure: 2.5 - 3.2 bar (36.25 - 46.4 psi)
3 - Oil spray nozzle For piston cooling
4 - Connecting rod bearing cap
^
Mark -13- to indicate which cylinder each cap belongs to
Installed position:
^
Marks -A- point toward belt pulley side
5 - Bearing shell
^
Verify correct installation position
^
Do not interchange used connecting rod bearing shells (mark accordingly)
^
Check for proper securing in retaining tabs
Axial play:
^
New: 0.10 - 0.35 mm (0.004 - 0.014 inch)
^
Wear limit: 0.40 mm (0.016 inch)
Measure radial play using Plastigage:
^
New: 0.01 - 0.05 mm (0.0004 - 0.0020 inch)
^
Wear limit: 0.12 mm (0.0047 inch)