A4 Quattro Wagon L4-1.8L Turbo (ATW) (2000)
Adjusting toe constant "S"
-
Loosen nut-A-.
-
Back out bolt -B- approx. 4 mm (1/8 inch).
-
Push tie rod end downward onto stop.
-
Turn in adjusting bolt -B- until exact specifications are achieved.
-
Tighten nut -A- to 45 Nm (33 ft. lbs.) and check values.
-
Tighten bolt -B- to 7 Nm (62 inch lbs.).
-
Lower vehicle to defined starting position B1 .
-
Screw threaded spindle down.
-
On vehicles with standard suspension, bounce suspension several times.
Checking toe constant after adjusting
The alignment unit checks the toe constant again.
-
If the second check shows that the values are within the check value tolerance, the setting is OK.
-
If the values are outside the check value tolerance, the setting must be adjusted again in position B2.
-
Position B2: + 60 mm (2.36 inch).