A4 Quattro Wagon L4-1.8L Turbo (ATW) (2000)
-
Tighten socket-head bolts for coolant pump pulley.
Tightening torque: 25 Nm (18 ft lbs)
-
Install fan at viscous coupling.
Tightening torque: 10 Nm (7 ft lbs)
-
Install ribbed belt.
CAUTION: Mark the running direction before removing. Reinstalling a used belt in reversed running direction could damage the belt.
Make sure that the belt is correctly seated in the pulleys.
Note:
Illustration is shown without the lock carrier installed for greater clarity.
-
Top off hydraulic fluid.
-
Install bumper, refer to Body and Frame - Bumper - Service and Repair - Procedures See: Body and Frame/Bumper/Front Bumper/Service
and Repair
-
Start engine and make sure ribbed belt runs properly.
-
Check hydraulic fluid level.
-
Bleed steering system, refer to Power Steering Bleeding - Service and Repair - Procedures See: Power Steering Bleeding/Service and Repair
-
Check steering system for leaks, refer to Power Steering Fluid - Testing and Inspection - Procedures See: Power Steering Fluid/Testing and
Inspection