A4 Quattro Wagon L4-1.8L Turbo (ATW) (2000)
Notes:
-
The two collars of the bonded rubber bushings must be flanged slightly before installing into lower control arm assembly device.
-
Be careful when attaching lower control arm assembly device.
-
Attach 3293 lower control arm assembly device to bushing with jaws of tool positioned between lip of bushing and lower control arm.
-
Screw in threaded stem to force bushing slightly from lower control arm.
Fig. 2 Attaching puller into lower control arm
-
Attach commercially available puller (e.g. Kukko 15-0) to lower control arm.
-
Insert 3118/8 adapter into hole in bonded rubber bushing.
-
Screw Kukko 18-0 into Kukko 15-0 and centrally align.
-
Screw in threaded stem -A- until bonded rubber bushing is pulled out.
Fig. 3 Pulling second half of bonded rubber bushing into lower control arm
-
Attach 3349 puller to lower control arm.
-
Screw in threaded stem of 3301/1 until second half of bushing is fully removed.
Fig. 4 Installing bonded rubber bushing into lower control arm
-
Insert two halves of bonded rubber bushing together with 3293/4 thrust pieces and threaded stem into lower control arm art right angles.
-
Turn threaded stem until bonded rubber bushing is pulled fully in up to stop.