audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Tire Monitoring System - TPMS Diagnostic Tool/Procedure|Page 2795 > < E-Gas System, Function Checking|Page 2788
Page 1
background image

Tire Pressure Sensor: Technical Service Bulletins
Tire Monitoring System - TPMS Diagnostic Tool/Procedure

44 TPMS Diagnosis With BRT-DBL4

44 09 03 

2019791/1 

March 17, 2009

Vehicle Information

Condition

TPMS light on.

Technical Background

Tire Pressure Monitoring Systems have become an industry standard and have been in Audi vehicles as optional equipment since MY 2000. Beginning
MY 2008, TPMS has been installed as standard equipment in all Audi models.

The TPMS warning indicator can illuminate for several reasons. The most common reason would be for underinflated tires. Tires may become under
inflated when:

-

The seasons or ambient temperatures change.

-

Tire pressure naturally decreases over time.

Until now, it has been difficult to determine on a service drive if the TPMS warning light came on due to underinflated tires or due to a system
malfunction.

With the introduction of TPM sensor tester BRT-DBL4, it is now possible to determine on the service drive if tire pressure was the cause for the TPMS
light's illumination. The BRT-DBL4 will work on all TPM sensors since MY 2000 by reading the sensors  transmitted information (for example,
pressure, temperature, sensor ID, and battery life)

With this TSB, Audi of America would like to offer some tips on best practices to get the most out of the new BRT-DBL- 4 TPM sensor tester.

Production Solution

Service

1. Upon arrival of an Audi with the TPMS light illuminated, scan all four tire pressure sensors with the BRT-DBL4 tester.

2. Compare the tire pressures read by the BRT-DBL4 with the vehicle s tire pressure information in the Owner s Manual.

3. If the tire pressure read by the BRT-DBL4 is lower than the tire pressure specified for this vehicle, adjust the tire pressure. The TPMS light should

extinguish after an ignition cycle, and the vehicle can be returned to the customer.

4. If the TPMS light remains illuminated after the tire pressures have been adjusted, a TPMS malfunction may be present. Further diagnosis of the

TPMS system will be necessary.

TIP:  The message No TPM Found usually indicates an inoperative sensor.

Warranty

This TSB is informational only and not applicable to any Audi warranty.

Additional Information

All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service

Tire Monitoring System - TPMS Diagnostic Tool/Procedure|Page 2795 > < E-Gas System, Function Checking|Page 2788