A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Trunk / Liftgate Shock / Support: Service and Repair
Gas-filled Strut For Rear Lid, Removing And Installing
Removing
-
Prop up and secure rear lid in open position.
-
Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut - 1 - from upper ball stud - 2 -.
NOTE:
-
Following complete removal of the gas-filled strut, check for correct positioning during installation.
-
Sound insulation component must be installed on the body side.
Installing
Installation is the reverse of removal, noting the following:
-
To install, press gas-filled strut onto ball studs so that it engages in position.
-
Ball stud tightening torque: 15 Nm(-1 Nm)