A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
-
Using the Test Box 105 Pin VAG1598/42 and Multimeter V.A.G 1526 A or equivalent, check the following wiring connection for an open circuit.
Terminal
Test box socket
2
20
Specified resistance 1.5 Ohms max.
If the specification is not obtained:
-
Check the wiring for a short circuit to Battery positive (+) or an open circuit.
-
If necessary, repair the wiring connection.
If no malfunctions are found in the wiring:
-
Replace the Engine Control Module (ECM) J623.
Assembly is performed in the reverse order of removal, note the following:
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory.
2. If necessary, erase the DTC memory.
3. If the DTC memory was erased, generate readiness code.
-
End diagnosis and switch the ignition off.