A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
-
Position guide sleeve T10070/1 of polydrive bit and drive socket T10070 on end of camshaft.
-
Slide seal over guide sleeve onto camshaft end.
-
Remove guide sleeve.
-
Press in seal with pressure sleeve T10071/3 and bolt T10071/4 from T10070 up to stop.
-
Install camshaft sprocket.
-
Note installed position: The thin rib of the camshaft sprocket points outward - arrows - and cyl. 1 TDC marking is visible.
-
Install bolt for camshaft sprocket using retainer 3036.
Note: By turning the camshaft, the valves could contact the stationary pistons at TDC. Therefore, the pistons must not be at TDC. Valves/pistons may
be damaged.
-
Install toothed belt Toothed belt, removing and installing.